• Welcome, Guest! We hope you enjoy the excellent technical knowledge, event information and discussions that the BMW MOA forum provides. Some forum content will be hidden from you if you remain logged out. If you want to view all content, please click the 'Log in' button above and enter your BMW MOA username and password.

    If you are not an MOA member, why not take the time to join the club, so you can enjoy posting on the forum, the BMW Owners News magazine, and all of the discounts and benefits the BMW MOA offers?

  • Beginning April 1st, and running through April 30th, there is a new 2024 BMW MOA Election discussion area within The Club section of the forum. Within this forum area is also a sticky post that provides the ground rules for participating in the Election forum area. Also, the candidates statements are provided. Please read before joining the conversation, because the rules are very specific to maintain civility.

    The Election forum is here: Election Forum

splines

  1. G

    clutch spline lube, @ 32ks?

    Haven't seen much about lubing the spline on my 2011 GSA.. Does anyone recommend it? That BMW mechanic on youtube Chris Harris, discusses clutch R1150 problems of not using the full length of spline on the trans input shaft.. I'm hoping that that was corrected on the later years... I...
  2. MGMcAnick

    Stuck clutch lever on '84 K100RT

    I have been offered a 1984 K100RT. It's a pretty clean bike, but it has not been run in nearly a year. You know, the "it was running when it was parked" story. They are asking $800 for it. I have looked it over pretty closely. One of the things I have found is that the clutch lever can't be...
  3. B

    1988 K100 RS questions

    I'm trying to check all splines by myself and get the machine going again. 1. What grease is recommended for the swing arm bearings? 2. What grease is recommended for the drive shaft universal joint? 3. I'm going to use a 50/50 mix of Honda moly 60 and Wurth 3000 for the splines as I...
  4. D

    /6 Rear drivetrain questions

    1974 R90 /6. This bike sat for 10 years, and I have recently been doing all the maintainence to bring it up to a reliable working status. I just finished adjusting the valves, and lubing the transmission splines as per Snowbum's procedure. 2 questions (for now) ;) 1. Is there a link or...
    • drpetecrocker
    • Thread
    • splines universal joint
    • Replies: 8
    • Forum: Airheads
  5. 20774

    Splines by Paul

    Must read article by Paul Glaves in the April 2010 ON on splines. It covers all bikes but has juicy tidbits for our Airheads. I really appreciated the review and I think his recommendations for lubrication are spot on. Thanks, Paul. :thumb
    • 20774
    • Thread
    • grease lubrication splines
    • Replies: 1
    • Forum: Airheads
Back
Top