Spinakr
New member
Greetings all,
I am unable to balance the throttle bodies on my '05 R1200RT.
With engine off, I used a GS-911 to park/Sync the stepper motors,
then with engine off I connected a Harmonizer and zero'd it out.
Started the bike and the 2 vertical slashes were far to the left at -30 mb.
I tried adjustment on the throttle side and had no room to go clockwise with the cable nut.
Turning counter clockwise only made the mb reading go lower to -49 mb.
I am unable to get the cable to adjust the display reading up in mb, or to the center of the display.
what am I doing wrong?
As usual, any help is very much appreciated.
Rob
I am unable to balance the throttle bodies on my '05 R1200RT.
With engine off, I used a GS-911 to park/Sync the stepper motors,
then with engine off I connected a Harmonizer and zero'd it out.
Started the bike and the 2 vertical slashes were far to the left at -30 mb.
I tried adjustment on the throttle side and had no room to go clockwise with the cable nut.
Turning counter clockwise only made the mb reading go lower to -49 mb.
I am unable to get the cable to adjust the display reading up in mb, or to the center of the display.
what am I doing wrong?
As usual, any help is very much appreciated.
Rob