bobframe
New member
I'm about to begin the installation of a Centech AP-2 fuseblock on my '06 R1200GS and have a question about the relay trigger circuit.
I plan to tap into the accessory port wiring on the left side of the bike (below seat). My wiring into this post has an additional circ uit branching off this that terminates about 3" from the plug and has a small plastic two prong female plug at the end of the wires. The wires that terminate into this female plug appear to be Brown and some other color. I'm guessing that the Brown is Ground (-) and the other color is Positive (+).
Is my guess correct?
Since the Aux. port is switched, I presume that this "extension" lead/plug is also switched.
Can I tap into the "other colored wire" for a trigger?
Why? For no other reason than it would be a bit easier to reach.
Many thanks,
Bob
I plan to tap into the accessory port wiring on the left side of the bike (below seat). My wiring into this post has an additional circ uit branching off this that terminates about 3" from the plug and has a small plastic two prong female plug at the end of the wires. The wires that terminate into this female plug appear to be Brown and some other color. I'm guessing that the Brown is Ground (-) and the other color is Positive (+).
Is my guess correct?
Since the Aux. port is switched, I presume that this "extension" lead/plug is also switched.
Can I tap into the "other colored wire" for a trigger?
Why? For no other reason than it would be a bit easier to reach.
Many thanks,
Bob