05-up R1200RT-P seat mounting
I purchased the fill in seat section off an 06 RT-P & i`m trying to figure out where the back mount slide pin bolts too. I`m fitting this onto my 2010 R1200RT non P & noticed also that the shock adjuster knob seems to be in the way also. Does anyone have a good pic of the mounting of this setup . I`m going this route , so i can run a fuel cell where the back seat would go & the filler is just perfect.
I also noticed on the bottom front of the fill in section , that it has a spring clip setup that slips onto something below the riders seat (need pics of that also. This way i can order the parts from Bobs BMW.
Hi, I have an 06 RTP but am a little vague on exactly what you are looking for. The P uses a the normal front seat then has two blocks (filler pieces at the rear of the seat) that slide sideways to gain access for seat removal and under seat service. Each of these two seat block halves slide together and hit you in the tail-bone while sitting on the seat.........are these blocks what you are addressing??
Originally Posted by roadstar
Thats for the reply , one member from another forum sent me a bunch of pics that were very helpfull & in the spring (after i recoupe) & will install them (modified a little) with the cell i`m picking up.
Originally Posted by BOBBBAY