boxwrench
New member
I installed a "one off " HID on the bike. To do this and mount the transformers behind one of the speaker grill I had to remove the dash.
I noticed then that some of the molded mount for the RID were broken.
This required i completely remove all connections.
So i got the light in & made the repairs , reconnected the wires and put in a pigtail for a charger.
However now the ABS light flashes and wont reset.
Oh, the only the I did to the system was to take off the reservoir cap and look inside.
I am pretty sure I got the connections right
Any help appreciated.
I noticed then that some of the molded mount for the RID were broken.
This required i completely remove all connections.
So i got the light in & made the repairs , reconnected the wires and put in a pigtail for a charger.
However now the ABS light flashes and wont reset.
Oh, the only the I did to the system was to take off the reservoir cap and look inside.
I am pretty sure I got the connections right
Any help appreciated.
