MechanicSavant
New member
does any one know if the cyl head re-torque @ 600 mi. is the same as on an 1150 .. 15ft/lbs then 90deg + 90deg and 30ft/lbs on the8mm bolt ???
-
Welcome, Guest! We hope you enjoy the excellent technical knowledge, event information and discussions that the BMW MOA forum provides. Some forum content will be hidden from you if you remain logged out. If you want to view all content, please click the 'Log in' button above and enter your BMW MOA username and password. If you are not an MOA member, why not take the time to join the club, so you can enjoy posting on the forum, the BMW Owners News magazine, and all of the discounts and benefits the BMW MOA offers?
-
Beginning April 1st, and running through April 30th, there is a new 2024 BMW MOA Election discussion area within The Club section of the forum. Within this forum area is also a sticky post that provides the ground rules for participating in the Election forum area. Also, the candidates statements are provided. Please read before joining the conversation, because the rules are very specific to maintain civility.
The Election forum is here: Election Forum
cyl head re-torque
- Thread starter MechanicSavant
- Start date
The_Veg
D'OH!
MechanicSavant
New member
Just what I needed , Thanx
jimvonbaden
Kool Aid Dispenser!
These are 20nm if you have to loosen them, try to find THEM in the manual or torque chart. I had a heck of a time.
The head bolts for retorque are 20nm plus 180 degrees.
The T-45 Torx is 40nm
This is slightly different than the initial torque of a new head gasket.
Jim
